Solid wood furniture is now gradually widely used in major hotels, and has been generally recognized by the majority of users, mainly solid wood furniture that is not only good quality, but also has a beautiful appearance, and that it has great color relationship. When solid wood tables and chairs just finished carving is very rewarding, it is to be carved after the color, we need to pay attention to certain matters when color. After carving wood tables and chairs do not immediately wipe light, color, did we have to wait (about 12 hours), with a clean cloth to wipe hard until a uniform gloss, to feel smooth. Some works, as the case may rub some of leakage, so the background is slightly exposed wood, form a rich sense of color, but also to strengthen the sense of hierarchy works. Mainly wood and master patterns also covered in paint still visible, some wood by coloring clearer. So solid wood tables and chairs in the deployment of color should not be too thick, pigment and water than the column is 30: 1, to the appropriate thin, it was transparent. So even multiple times, the wood will not be covered if the proper color matching, color brush pen water content should not be too much, not anxious, otherwise some deep recess heritage colors easy to produce uneven results.

Solid wood furniture design quality using four criteria to measure, that is, solid wood tables and chairs practicality, aesthetics, technology and economy. Where practicality is the most basic, all solid wood tables and chairs should be practical as far as possible on the basis of aesthetics, economy and ease of processing. No practical value, wooden tables and chairs will lose the meaning of existence. However, other aspects can not be neglected. Practicality, aesthetics, technology and economy have both at the same time, this is the principle of solid wood furniture design must be followed. Solid wood furniture design content, including the appearance of solid wood tables and chairs phase structure, and the structure of the method include mutual engagement between the overall shape of the solid wood tables and chairs, the size of each part of the material, shape, size, parts, and finishing requirements Wait. Exterior design of solid wood dinette determine the shape, size and shape of the engine shown in Fig., The views of users, modify stereotypes. Bonding method to determine the structural design of each part of the material, shape, size, and between the various parts of the structure to draw sketches, solicit the views of producers, modify foot draft. Single-piece production and small amount of production, the design ended. If mass-produced, the need to make the sample, and then make changes to the original design, and the official draw solid shape and structure. Finally, the material calculated to serve as basis for preparation.